WALL COATINGS
#774 WALLGARD GEL
BLOCK FILLER GEL MADE OF 100% SOLIDS EPOXY
DESCRIPTION: An ultra-high viscosity, two-component 100% solids epoxy gel for pre-filling irregular surfaces such as “bug holes” in concrete, and voids in CMU. Typically applied with a trowel and back rolled.
WALL SYSTEMS
Thermal-Chem’s Epoxy Wall Coating Systems offer a wide selection of performance characteristics to fit even the most demanding needs and allow for application over most existing or new substrates. These versatile systems make it possible to install a seamless, ceramic-like epoxy wall coating system while having virtually no odor during installation. WallGard systems are USDA approved and VOC compliant. Matched with an appropriate Thermal-Chem floor system, these epoxy wall coatings can provide a seamless, protective, easy-to-clean surface from the ceiling all the way to the drain. Designed to withstand the harshest environments in industrial, institutional and commercial facilities, they can be applied as a decorative finish and/or can be reinforced to add strength & durability. The three novolac WallGard epoxy wall systems (HP, AR and SR) are three distinct chemical resistant formulations that are capable of resisting a wide range of chemicals in even the harshest and most severe environments.
ADVANTAGES
- 100% solids formulations producing no offensive odors during application
- Quick Installation times for quick return to service projects
- Cost-effective alternatives to FRP (fiberglass reinforced panels)
- Decorative flake can be applied to offer a high-end decorative look
- Easy to clean, for years of use
- Can be used for both walls and ceilings
- Can be hand-applied or spray applied USDA approved
DATA SHEET
SURFACE PREPARATION
- All wall or ceiling surfaces should be cleaned, dry and peeling paint or coatings must be removed.
- For concrete and CMU surfaces makes sure that at least 28 days have passed since these were installed to ensure all moisture used is gone. Once dry a CSP 2 surface profile as defined by ICRI Guideline No. 03732.
- Any large holes can easily be pre-patched using #774 WallGard Gel epoxy block filler.
LIMITATIONS
- Minimum temperature for application is 50° F
- Porous substrates such as drywall and wood, must be primed using Thermal-Chem’s #726 ArmorPrime
- Refer to Thermal-Chem’s Chemical Resistance Guide if the project is to be exposed to chemicals
GET A FREE QUOTE
The experts at Thermal-Chem can provide you with expert advice and free quotes for your specific project. Call or email now.