URETHANE CEMENTS
#1030-TR THERMALCRETE TROWEL
TROWELED URETHANE CEMENT
Thermal-Crete TR #1030 is a trowel applied (3) three- component, cementitious polyurethane cement flooring system for medium to heavy-duty use for interior applications. Thermal-Crete TR #1030 has a similar coefficient of expansion similar to concrete allowing this flooring system to tolerate large temperature swings (thermal-shock) and service exposures to wet and dry temperatures up to 260 degrees F.
PACKAGING & COLORS
Kit is pre-measured 1 gallon each of both parts A & B, along with part C which is (2) 64 lb. bags of A112 Crete Slurry #9A.Slurry Sand.
ADVANTAGES
- High compressive strength
- Excellent resistance to thermal shock
- Very rapid cure formulation resulting in minimal downtime
- Tolerates higher than normal moisture vapor transmission rates (MVTR)
- Can be applied to freshly poured concrete after a minimum of 7 days
- Extremely durable
- Low odor during application & cure-can be applied in occupied facilities, USDA accepted
- VOC compliant with ALL U.S. regulations
- Can be factory or field pigmented using Thermal-Chem’s Universal Pigment
USES / APPLICATIONS
DATA SHEET
LIMITATIONS
- Can be applied in ambient temperatures as low as 50 Degrees-F
- Do not apply when project humidity is greater than 70%
- Do not thin this product
- Consider top coating Thermal-Crete if applied in areas with higher than normal UV exposure
APPLICATION INFO
Slowly pre-mix (1) one gallon of Part A, then add (1) gallon of Part B. If using pigment/colorant add to
Part B and drill for one minute at low r.p.m. Then add 64 lbs. of Part C aggregate and drill for an additional 3 minutes, until all three components are thoroughly mixed. (Note: Each part is pre-measured and partial mixes should not be used)
Apply using a gauge rake or screed pre-set for desired thickness. A spiked roller can be used to help level the mixture and aid in the release of air entrapment. Broadcast TC A 108 silica sand to rejection.
Once properly cured, remove excess silica sand. Additional topcoats may be applied at this time.
SURFACE PREPARATION – Apply ThermalCrete #1030 TR only to clean and sound substrates. Mechanical preparation by means of shot- blasting or diamond grinding to an ICRI CSP 3/4 is recommended (see ICRI Guideline No. 03732 for additional details).
GET A FREE QUOTE
The experts at Thermal-Chem can provide you with expert advice and free quotes for your specific project. Call or email now.