PRIMERS AND BASE COATS
#1080 ARMORPRIME WB
WATER-BASED EPOXY PRIMER
ArmorPrime-WB #1080 is a two-component water-based epoxy that acts as a multi-functional primer or as a sealer. A great choice to seal older concrete surfaces to prevent out-gassing and air bubbles from transmitting through subsequent coatings.
When applied in two or more coats, ArmorPrime-WB #1080 produces a very durable sealer coat. (For interior use only)
PACKAGING & COLORS
Kit sizes available are 1, 3, 15 gallons
ADVANTAGES
- Cost-effective
- Cures extremely fast to allow quicker return to service
- VOC compliant with ALL U.S. regulations
- Extremely low odor during application & cure – can be applied in occupied facilities
- VOC compliant with ALL U.S. regulations
- Very low viscosity provides deeper penetration into even the smallest voids in concrete
- Can be applied to “Green” concrete
USES / APPLICATIONS
- Most often used as an economical primer.
- Used as an economical two-coat system to act as a sealer, densifies the concrete, and provides long term wear economically.
DATA SHEET
LIMITATIONS
- Do not apply in ambient temperatures below 50° F or above 80° F
- Do not apply with relative humidity above 80%
- Do not thin this product with any solvent
- Do not tint this product
APPLICATION INFO
Apply ArmorPrime-WB #1080 with a squeegee, brush, or high-quality non-shed roller. Only mix the amount of product that can be properly applied within 20-35 minutes. Once thoroughly mixed this product should be placed on the surface and NOT LEFT IN THE MIXING BUCKET.
SURFACE PREPARATION – Apply ArmorPrime-WB #1080 only to clean and sound substrates. Mechanical preparation by means of shot- blasting or diamond grinding to an ICRI CSP 2/3 is recommended (see ICRI Guideline No. 03732 for additional details).
GET A FREE QUOTE
The experts at Thermal-Chem can provide you with expert advice and free quotes for your specific project. Call or email now.