CLEAR POLY TOPCOATS
#1065 DECOFINISH
ALIPHATIC URETHANE – SATIN – LOW ODOR 81% SOLIDS
DecoFinish #1064 M and DecoFinish #1065 S are clear 57% solids, two-component aliphatic urethane coatings.
Both products provide excellent chemical, abrasion, and stain resistance. DecoFinish #1064 M and DecoFinish #1065 S are perfect coating systems for interior or exterior applications where the finished surface may be exposed to high wear abrasion and ultra-violet light. These products offer a “muted” gloss finish, if a high gloss is required use Thermal- Chem’s #1057.
PACKAGING & COLORS
Kit sizes are available are 1,2, 10 gallons
USES / APPLICATIONS
-
A truly satin finish that mutes the base color underneath
ADVANTAGES
- Water-clear formulation
- Excellent abrasion resistance
- Easy 1 to 1 mix ratio
- Excellent UV Resistance
- Alternative finishes compared to typical high-gloss products
DATA SHEET
LIMITATIONS
- Do not apply directly to concrete
- Do not apply directly to wood
- Do not apply in conditions with high humidity
- Do not apply at a thickness greater than 5.3 mils (300 sq. ft./gal)
- Avoid allowing “puddling” during application
- Contains solvents and must be used in areas that are properly ventilated
APPLICATION INFO
Surface Preparation: New concrete must have a 28-day cure and be applied to a clean/sound substrate that is free of laitance and curing compounds. Mechanical preparation by means of shot-blasting or diamond grinding to a minimum of a CSP 2/3 as defined by ICRI, then properly vacuumed to remove any remaining dust.
Mixing: Mix both components for approximately 2-3 minutes. CAUTION: if mixing solvent-based products with an electric drill, sparks may ignite solvent odors. Whenever possible use a battery-operated cordless drill.
Applying Product: These products yield better results using a “dip and roll” application method. Do not let material “puddle”. If this material is allowed to puddle in low spots, small white bubbles may appear.
Back roll the material in both directions onto the surface. DO NOT TURN THE MIXING VESSEL (BUCKET) OVER ON THE FLOOR IN AN EFFORT TO UTILIZE THE ENTIRE CONTENTS.
The “dip & roll method appears to yield the greatest success, use a non-shed 1⁄4” or 3/8” nap roller cover.
Typical Coverage will be between 200-300 square feet per gallon. This will vary depending on the surface to which the mixed product is applied.
GET A FREE QUOTE
The experts at Thermal-Chem can provide you with expert advice and free quotes for your specific project. Call or email now.